Bienvenidos a Highend Iniciar sesión o bien registrarse.
FONO: 56 02 2453 7654
Highend > Amplificadores > VS115 Audio Research

VS115

Audio Research
 
 
 
COTIZAR:

The VS115 revisits the classic look of the VS110 with its open architecture and natural anodized top plate – now more ventilated for better heat dissipation. Drawing upon the successful REF110 input stage design, the VS115 uses a FET input with two 6H30 triodes in each channel for gain and as a cathode follower-driver for the KT120-equipped output stage. This allows both balanced and single-ended connections in a true differential topology yielding a much wider power bandwidth (110kHz in contrast to 40kHz for the VS110). There is a new power transformer, and power output from the four matched pair of KT120 output tubes is 120WPC, providing excellent drive and control. Bias test points for each output tube are located on the rear panel, along with a 12V trigger which allows remote turn-on. A heavy 20-amp IEC detachable cord conducts the A.C. supply.

While the VS115 physically resembles the discontinued VS110, sonically it is in another league. The VS115 immediately makes clear its wider power bandwidth with more speed, top-end air, improved resolution and more articulate, impactful bass. Textures and timbres are finely rendered and silky-smooth, with the grainless resolution of which only our Reference series amps have previously been capable. In short, the new VS115 is highly engaging, musically rewarding and an unparalleled performer at its price. For the music lover who wants the best attributes of tubes in both style and performance, the VS115 is a new amplifier that will be impossible to resist.

POWER OUTPUT:120 watts per channel continuous from 20Hz to 20kHz. 1kHz total harmonic distortion typically 0.5% at 120 watts, below .05% at 1 watt.

FREQUENCY RESPONSE: (-3dB points at 1 watt) 0.8Hz to 100kHz.

INPUT SENSITIVITY:1.6V RMS Single-ended or Balanced for rated output. (26dB gain into 8 ohms).

INPUT IMPEDANCE: 150K ohms Single-ended, 300K Balanced.

OUTPUT TAPS: 8 ohms, 4 ohms.

OUTPUT REGULATION: Approximately 1.2dB 8 ohm load to open circuit (Damping factor approximately 8).

OUTPUT POLARITY: Non-inverting. SE or BAL PIN 2+ (IEC268)

HUM & NOISE: Less that 0.2mV RMS
104dB below rated output
(IHF weighted, input shorted).

POWER SUPPLY ENERGY STORAGE: Approximately 332 joules.

POWER REQUIREMENTS:105-125VAC 60Hz (210-250VAC 50Hz) 690 watts at rated output, 900 watts maximum, 400 watts at \"idle.\"

TUBES REQUIRED: 4 - Matched pair KT120 — Power Output; 4 - 6H30 gain and driver.

DIMENSIONS: 17.5\" (44.5 cm) W x 7.9\" (20.1 cm) H x 19\"(48.3 cm) D. Rear connectors extend .88\" beyond chassis.

WEIGHT: 62 lbs. (28.2 kg) Net; 70 lbs. (31.8 kg) Shipping.

Specifications subject to change without notice.

Deje su comentario


Nombre:
E-Mail
Reviews Audio Research VS115